The LocateWater sensor is a rope type water sensor designed for specific location water detection.
The LocateWater sensor can be connected to any one of the SensorProbe or SecurityProbe’s RJ-45 Intelligent Sensor ports enabling the unit to detect the specific location of water ingress. This water sensor is a switch type that will be on or off and will detect the presence of water if a specific location on the rope becomes wet.
This sensor is ideal when monitoring for water leaks under raised floor, or false ceiling areas.
This sensor comes fully assembled and includes the rope portion that is the water sensing cable, the non-sensing area cable (from the rope to the sensing module) and the main sensing module. The sensing cable can be pre-ordered from a 10 foot minimum to any custom run length (in multiples of 10 feet - Please call for custom lengths) of up to 160 feet. The non-sensing cable comes in a standard 20 foot run length. See the detailed diagram of the sensor assembly above or on page 2 of the datasheet.
The specific location of water along the rope can be used to trigger alerts like e-mail, SMS, phone calls and SNMP traps. The sensor has its own SNMP OID so that it can be monitored over the network using any Network Management System.
Each LocateWater sensor comes complete with a 5 foot CAT5 cable that connects the main sensing module to the SensorProbe's or SecurityProbe's RJ-45 sensor ports, or you can use your own CAT5/6 LAN cable. This cable can be up to 100 feet (30 meters) in length.